Table of Contents
Advertisement
Important: The Empty After Printing option is checked
by default. If you are printing a part with especially delicate
features, uncheck this option. Also refer to the ZPrinter
850 User Manual for information on adding fixtures and
bumpers to help protect delicate parts.
7.
If all the Print Heads, Powder, and General items display
OK, the Print button is enabled. Click Print to start your
build.
NOTE: Before starting the build, the printer will:
•
Service the print heads.
•
If necessary, print an alignment pattern and align the
print heads.
•
Fill the Build Bed with
powder and then spread
one layer to make the
Build Bed surface smooth.
8.
The Printing dialog opens
and reports the status of the
print job for the duration of
the build.
This dialog details:
•
Estimated print finish time.
•
Estimated remaining print time.
•
Actual print start time.
•
Actual print elapsed time.
3dscentral.3dsystems.com
•
The layer that is currently printing and the percentage
completed.
The Printing dialog also provides:
•
The Pause button. Click to pause the current print job,
Click again to resume printing.
•
The Cancel button. Click to cancel printing this job.
9
Advertisement
Table of Contents
