Table of Contents
Advertisement
gee.
4.
Use the cotton swabs or
a paper towel and wipe
the front and back of
the squeegee. Use the
Pick to scrape excess
powder out of any cor-
ners.
18
1.Place paper towels
around the Service Sta-
tion, and between the
Service Station and the
Build Bed.
2.Cover the front over-
flow with paper towels.
3.Position the squirt
bottle close to the sta-
tion and squirt water on
and around the squee-
6.
Install a needle onto the
small syringe. Gently push
the tip of the needle
through each of the six
Wash Holes to clear them.
7.
Wipe off any water or
wash fluid on the Wash
Holes. Thoroughly wipe
the Service Station clean.
8.
Wipe up any water that
may have spilled onto the
Deck or Build Bed.
9.
Remove the paper towels from the Front Overflow and dry it
thoroughly.
10. Close the printer top cover.
5.Remove the spit plate
from the Service Station
and clean it with a paper
towel. Replace the spit
plate, using the edge tabs
for correct alignment.
3dscentral.3dsystems.com
Advertisement
Table of Contents
