Add Cleaning Solution; Replace The Waste Tray - 3D Systems ProJet x60 Series User Manual

®
ProJet x60 Series User Guide
Do not continue running the vacuum after the Feeder is Full message appears. If you continue to vac-
uum material into the feeder, the LCD will display FEEDER LIMIT and the vacuum will be disabled.
5. Remove the container and return the vacuum hose to its stand.

5.6 Add Cleaning Solution

To add Cleaning Solution, follow the steps below.
1. Open the top cover and then open the Service Station cover.
2. Hold down the top of the service station while pulling off the red cap.
3. Remove the red cap. Add Cleaning Solution until the tank is HALF full. Do not overfill.
4. Replace the cap and close the Service Station cover.
5. Reset the Maintenance Counter in 3D Print. See the 3DPrint Software Manual for details on how to
do this.

5.7 Replace the Waste Tray

If the Waste Tray is Full, 3DPrint displays
To replace the Waste Tray, follow the steps below.
1. Remove rear cover.
2. Pull the full Waste Tray out of its compartment on the printer.
3dscentral.3dsystems.com
5/12/13
THE FEEDER IS FULL
AUTO SHUTOFF IN 10 SEC
KEEP VACUUM ON
EMPTY WASTE TRAY
39
Additional Operations
in the Printer Status dialog.
All Rights Reserved