Table of Contents
Advertisement
6.2 Clean The Debris Separator
The purpose of the Debris Separator is to keep any large parti-
cles from going back into the Feeder during vacuuming.
4.
Using a stiff brush, clean the screen located inside the
Debris Separator receptacle on the printer.
14
1.Pull the Debris Separator out
of its holder on the printer.
2.Empty the contents into a
trash receptacle.
3.Use the soft brush found in
the Accessory Kit to brush
caked on powder from the
screen.
5.Return the empty Debris
Separator to its holder. Be sure
to push the Separator flat
against the panel for a secure
fit.
6.3 Clean the Parking Caps
The Parking Caps keep the print heads from drying out between
print jobs. Cleaning the Parking Caps after every build results in
longer lasting print heads and precise accuracy during printing.
The Parking Caps are located on the right end of the Fast Axis.
Before you begin:
•
Get several dry paper towels.
•
Get the squirt bottle included in your Accessories Kit.
•
Fill the squirt bottle with distilled water.
•
Wear disposable gloves.
1.
Pull the Fast Axis toward you and slide the Printhead Car-
riage to the left to expose the Parking Caps.
Parking Caps
(5 total)
2.Lay paper tow-
els on the Build
Bed under and
around the Park-
ing Caps. Be sure
to cover the Front
Overflow with
paper towels to
keep water out.
3dscentral.3dsystems.com
Advertisement
Table of Contents
