3D Systems ZPrinter 850 Quick Start Manual page 15

Service Carriage
Station
3. Squirt the dis-
tilled water onto
the Caps. The
water should
drain out through
the Spittoon
under the Caps.
3dscentral.3dsystems.com
Paper Parking
Towels Caps
Parking
Caps
7. Be sure the Parking Caps are completely dry before starting
your next build.
Note: If the Caps are very dirty, or if washing them as above is
not sufficient, then remove the Caps from the printer and wash
them under running water. Dry them thoroughly before reinstall-
ing them in the Fast Axis.
4.Use a dry paper towel to
wipe the caps clean.
5.Remove the paper towels
from the Deck and wipe up
any water on the Fast Axis
or Deck.
6.Remove the paper towels
from the front overflow and
dry it thoroughly.
15