Table of Contents
Advertisement
4.
Select File > 3D Print, or click
the Printer Status dialog.
8
on the Toolbar, to open
5.
ZPrint checks each item in the Printer Status dialog prior
to printing to ensure there are enough materials to complete
the build.
•
See
Section 8
of this guide for instructions if you see a
message saying any of the items needs attention.
•
Click the Details button to view usage information for
each print head, the binder, and the powder.
6.
Check or uncheck Print Job Options for the current build.
•
Print in Monochrome will print the entire exterior of
the part using clear binder. The finished part will be
white on the outside. The interior will be gray or black.
•
Preheat Build will cause the printer to turn on the
heater in the build chamber prior to printing. This
warms the powder and binder, and is used for certain
combinations of powder and binder. Visit the Materials
section of our Web site at
to learn more about which binders and powders would
benefit from preheating.
•
Delay Start Time allows you to start the print job at a
later time. This is useful if you wish to have the print
job complete at a particular time.
•
Empty Build Piston after Printing will empty the
build bed of loose powder when the print job is com-
plete. The printer turns on the vacuum system and
vibrates the build bed to evacuate the powder. The
powder is then recycled to the feeder.
3dscentral.3dsystems.com
3dscentral.3dsystems.com
Advertisement
Table of Contents
