Table of Contents
Advertisement
3.12 Customer Supplied Equipment
The equipment listed below is not a part of the DMP Factory 350 system. The customer can purchase this equipment from an
independent source or from 3D Systems (if so indicated).
3.12.1 Main Power Supply Cable
Supplied by: Customer
Installed by: 3D Systems
Required
Due to local differences in power cable standards, the DMP system does not come with a mains power supply cable. Prior to
installation the customer is responsible for supplying a main power supply cable with the following specifications:
•
EU: 5G (3 PH + 1 N + 1 GND) 6 mm²
•
US: 5G (3 PH + 1 N + 1 GND) 10 AWG
3.12.2 Vacuum Cleaner
Supplied by: Customer or 3D Systems
Installed by: Customer
Required
Installations must have a wet separator, explosion-proof vacuum cleaner . Use of the equipment and explosion risk assessment
should be in accordance to local regulations.
Recommended extraction systems and wet separator vacuum cleaners might vary for different types of powders. Please ensure
to comply with local regulations and manufacturer specifications.
For more detailed information on the use of a wet separator vacuum cleaner to clean the machine, please
refer to the DMP Safety Guide (p/n: 80-D0712).
3.12.3 Floor Cleaning Machine
Supplied by: Customer
Installed by: Customer
To maintain a clean environment it is recommend that you purchase a floor cleaning machine.
3.12.4 Oxygen Monitor
Supplied by: Customer or 3D Systems
Installed by: Customer
Highly recommended
When working with argon, the customer is responsible for installing all appropriate facility safety devices as dictated by local
regulation. If required by local regulation a room area oxygen monitor (p/n: 23746-101-01 for 120VAC UL or p/n: 23746-101-
02 for 220VAC CE) can be purchased from 3D Systems. Customer is responsible to ensure these models are suitable for their
facility.
3.12.5 Dust Extraction System
Supplied by: Customer
Installed by: Customer
Highly recommended
3D Systems recommends a whole room, dust extraction system to remove airborne dust out of the air any time metal powder is
handled.
3D Systems, Inc.
15
p/n: 15-D99, rev. C
Advertisement
Table of Contents
