Table of Contents
Advertisement
Pogo Pins
9.
Remove the new print-
head from its packaging.
Be sure to pull the tape
tab off of the new print-
head.
10. Insert each new print-
head. Press down firmly
on the top of the print-
head, at the same side as
the pogo pins, to securely
fit a printhead into its
slot.
3dscentral.3dsystems.com
8.For each printhead being
replaced, wipe off all the pogo
pins (inside the carriage) with
the alcohol swab. Use additional
swabs if needed.
11. Close the carriage cover by pressing down until you hear it
click shut. Be sure both latches are engaged.
12. Close the printer top cover. Select
on the LCD.
The fast axis reparks and the printer goes Online. The
printer purges the new printheads and runs an auto-align-
ment pattern before the next print job to properly align the
print heads.
then
CONTINUE
EXIT
27
Advertisement
Table of Contents
