Hydraulic Generator (Option); Electrical Inverter (Option); Winching And Towing Procedures - Skyjack SJ-7027 Operating, Maintenance And Parts Manual

Hydraulic Generator (Option)

1. To start the hydraulic generator, Ensure the
engine is on high throttle by selecting "HIGH"
on the "Low/High Throttle Select" switch. Select
the "LIFT" position with the "Off/Lift/Drive" key
switch, then depress hydraulic generator push-
button on the side of the operator's control box.
The push-button will illuminate and generator
on base will start. To restore normal operation,
depress push-button again. The light in push-
button will go out and the generator will turn off.
Note
While hydraulic generator push-button switch light is
illuminated, the lift and drive circuits in the Operator's
Control Box are cut out.

Electrical Inverter (Option)

1. Turn the main disconnect switch to the "ON"
Position.
2. Turn the "ON/OFF" switch located on the front
face of the inverter to the "ON" Position.
3. Start the machine and turn the throttle switch to
the high idle setting.
4. Inverter activation is indicated by a glowing green
LED on the front face of the inverter.
5. To turn off the inverter, shut down the platform
engine and/or slide the "ON/OFF" switch on the
inverter to the "OFF" position.
Note
The inverter will only supply power to the platform
when the engine is running and the throttle switch is
set to the HIGH idle position. Deselecting the high idle
throttle setting or stopping the engine will turn the
inverter off.
SJ-600 Series Engine Powered

Winching And Towing Procedures

When Towing, DO NOT
or brake the towing vehicle rapidly.
Parking Brake System
1
Figure 2-13. Disc Parking Brake
1 - 3. Parking Brake Disc -This device disengages
the brake disc(1) when driving forward or in reverse. A
hydraulic brake cylinder(2), linked to a disc
caliper(3), engages and disengages a brake disc on
the rear axle drive shaft yoke. The brake MUST be
manually disengaged for pushing, towing or winching.
DO NOT push or tow the work platform onto a
downward slope or pull the platform down an incline
towards the winch.
manually disengaging the parking brake is as follows:
DO NOT manually disengage the parking brakes if
the work platform is on a slope.
June 2001
Warning
drive onto a downward slope
The special procedure for
Warning
SECTION 2, Page 11
2
3