Panasonic Kx-A406 Repeater; Location Of Controls; Additional Setup; Setting Up A Repeater - Panasonic NEXTIVA KT-TGP 600 User Manual

Panasonic KX-A406 Repeater

The Panasonic KX-A406 is a small hardware add-on to the Panasonic KX-TGP600. It is designed to sync to the Panasonic
KX-TGP 600 base unit and repeat the signal to up to 4 handsets outside the range of the base unit. The repeater doubles
the range of the base unit for the handsets by adding an additional 50m range to the base unit. A total of three repeaters
may be synced to the base unit in a "cascade" style setup, effectively quadrupling (200m) the range of the Panasonic KX-
TGP 600 base unit for up to 4 handsets.
Each repeater must be purchased separately and in addition to the base unit.

Location of Controls

Below is the location of controls for the Panasonic KX-A406 repeater, an optional accessory (Figure 8-1).
1. RSSI/ID Indicator
2. STATUS indicator
3. DC jack

Additional Setup

Setting up a Repeater

A repeater is used when you need to extend the range of a handset to areas where reception was previously not available.
A repeater extends the range in all directions, allowing several floors to be covered. You must register the repeater to the
Panasonic KX-TGP600 base unit before the repeater can be used. Follow the instructions below to do this.

Enabling Repeater Mode through the Phone Menu

1. Pick up a handset registered to the Panasonic KX-TGP600 base unit from the charger.
2. Press the Menu softkey (middle softkey) at the bottom of the screen.
3. Select System Settings  Repeater Mode  On from the menu.
Figure 8-1: KX-A406 – Location of Controls
4. PROGRAM Button
5. Hook
46 | P a g e
© Nextiva, All Rights Reserved