Checking The Firmware - Panasonic NEXTIVA KT-TGP 600 User Manual

12. Click the green Finish button at the bottom of the screen. A pop-up message appears saying the
user was successfully assigned to the device. Click the X in the upper-right corner of the pop-up
message to close it (Figure 3-10).

Checking the Firmware

The Panasonic KX-TGP 600 should be on Firmware 1.30. The steps below detail how to upgrade the
firmware if necessary.
1. Turn Embedded Web On. From the main screen, select Menu  Setting Handset  Other
Option  Embedded Web  On.
2. On the Panasonic KX-TPA60 handset, press the MENU softkey (middle softkey).
3. Select System Settings  Status  IPv4 Settings  IP Address from the menu.
4. Record the IP address that appears on the screen.
5. Enter the IP address into the address bar of a web browser on your computer (Figure 3-11).
Figure 3-10: Confirmation Message
Figure 3-11: Navigate to the Phone's IP Address
15 | P a g e
© Nextiva, All Rights Reserved