Installed Rogue2 Structural & Installation Checklist - S.R.Smith ROGUE2 Owner's Manual

PROPER SLIDING POSITION
Slide users must use the sitting slide position, facing forward, feet first as shown in
Figure 1.
INSTALLED ROGUE2 STRUCTURAL & INSTALLATION CHECKLIST
After installation and prior to the first use of the ROGUE2 and periodically (see
DAILY/WEEKLY MAINTENANCE OF THE ROGUE2) thereafter the owner must:
1. INSPECT THE RUNWAY FOR VISIBLE CRACKS OR TEARS.
3. INSPECT THE LADDER FOR SHARP EDGES, PROTRUSIONS, CRACKS OR TEARS.
4. INSPECT LADDER AND PEDESTAL MOUNTING AREAS FOR LOOSE OR CORRODED
FASTENERS.
5. MEASURE THE FOLLOWING DIMENSIONS AND COMPARE WITH THE MANUFACTURER'S
PLACEMENT INSTRUCTIONS ON PAGES 5, 6, AND 7.

POOL WATER DEPTH AT THE BASE OF THE SLIDE SHOULD BE AT LEAST 3' (914 MM) DEEP, AND AT
4'6" (1372 MM) OUT FROM SLIDE EXIT, SHOULD BE AT LEAST 4'6" (1372 MM) DEEP.

THE HEIGHT OF THE SLIDE RUNWAY EXIT ABOVE THE WATER SHOULD BE 20" (508 MM) MAXIMUM.

THE DISTANCE BETWEEN THE SLIDE CENTERLINE AND THE EDGE OF OTHER POOL EQUIPMENT
SHOULD BE AT LEAST 3'6" (1067 MM).
6. OBSERVE THE POSITION OF THE EXIT OF THE SLIDE AS SHOWN IN FIGURES 2, 3 AND 5
ON PAGES 6 AND 7.
7. READ, UNDERSTAND AND ENFORCE ALL SAFETY AND USE INSTRUCTIONS ON THE
SLIDE.
Figure 1
4