S.R.Smith ROGUE2 Owner's Manual page 7

3. SLIDE PLACEMENT INSTRUCTIONS FOR INSTALLATIONS ON POOLS WITH OTHER SLIDES
AND/OR DIVING BOARDS
A. The minimum clearance area in front of a properly installed diving board on an inground
swimming pool is a minimum distance of 3'-6" (1067 mm) on either side of the board's centerline
as shown in FIGURE 4. Pt. C extends a minimum distance of "C" from the tip end of the board as
shown in FIGURE 4. The width distance "W" on either side of Pt. C is given in CHART 1 and
shown in FIGURE 4.
BOARD MINIMUM CLEARANCE AREA
"C" DIMENSION
POOL TYPE
14'-6" (4420mm)
I
14'-6" (4420mm)
II
16'-6" (5029mm)
III
18'-6" (5639mm)
IV
21'-0" (6401mm)
V
Dimensions are in feet/inches and (millimeters)
See Article 5 contained in ANSI/APSP/ICC-5 2011
STANDARD FOR RESIDENTIAL INGROUND SWIMMING
POOLS and refer to FIGURE 3 and Table 1 for Minimum
Water Envelope Dimensions AB, BC and Width at Point C.
"C" DIMENSION FOR BOARD = AB + BC
"W" DIMENSION FOR BOARD = WIDTH AT PT.C
A. The minimum clearance area of a slide or diving board shall not intersect any coping or rope and
float line as shown in FIGURE 5. The minimum clearance area of a slide or diving board may
intersect each other provided that they are not used simultaneously.
CHART 1
"W" DIMENSION
5'-0" (1524mm)
6'-0" (1829mm)
6'-0" (1829mm)
7'-6" (2286mm)
7'-6" (2286mm)
FIGURE 5
7
(1067 (1067
mm) mm)
FIGURE 4