Electrolux W365H Service Manual page 56

12
Continued from previous page
4. Replace X3. Remove the contactor X312 and
Fig.
measure the resistance of the contactor with
33
the motor cabling between X312:4 - 5.
Contact
Internal error in the thermal sensor of the motor
controller detector.
5. Switch of the wall-mounted power switch. Undo the
contactor at X3 on the motor. Use an ohm meter to
measure the resistance towards the motor. Measure
between 1-2, 1-3 and 2-3. Correct resistance should be 2
Ω
- 5 (depending on the motor rating).
Correct resistance
Troubleshoot the cabling between the motor and motor
controller.
30
12. Troubleshooting
Interruption
Defective cabling
between motor
controller and motor.
Inspect the cabling and
replace if necessary.
One of the resistance
values is incorrect
The motor is probably
defective.
33
FLASH
EPROM
X312
Service
Manual
5930
438 9152-31/06
05.03