Electrolux W365H Service Manual page 51

Service
Manual
22E
The level system indicates such a wrong value
at program start that the automatic level
calibration cannot correct the fault.
This error code can only be generated at
Fig.
28 programme start. It implies that the machine
detects the water level to be above the
calibration level.
First verify that:
• the drain is not blocked by fluff or foam
• the same error appears again following
resetting of the error code
• the level hose and air box are not blocked
(blow into the level hose)
• for machines with a drain pump, verify correct
operation.
Pay attention to temperature extremes in the
surrounding which may affect the level system,
generating this error code.
1. Verify whether there is any water in the drum.
Water in drum
2. Enter the service programme and enter code
Fig.
24 (level control). Record the value. Disconnect
29
the level hose from the programme unit card
A1.
Level value does
not change
The level hose is probably blocked by fluff
or installed incorrectly. Verify and clean, or
replace the hose.
The level detector on programme unit card A1 is
defective. (By pressing START, it is possible to use
the washing programming without an optimally
adjusted water level until a new programme unit
card is installed.)
Verify the operation of the drain valve using the service
programme (code 22). Remedy or replace the defective
drain valve if necessary.
438 9152-31/06
05.03
12. Troubleshooting
No water in drum
Level value falls
28
Limit
measurement
range
Safety level
Calibration level
29
3350
Alt.
Level hose
connection
12
5419
Level hose
connection
Alt. 5566 C
25