Electrolux W365H Service Manual page 42

12
06E
The water level is too high at programme start
(above the safety level).
First verify that:
• the drain is not blocked by fluff or foam
• the same error appears again following
resetting of the error code
• the level hose and air box are not blocked
(blow into the level hose)
• for machines with a drain pump, verify correct
operation.
Pay attention to temperature extremes in the
surrounding which may affect the level system,
generating this error code.
1. Verify whether there is any water in the drum.
Water in drum
2. Enter the service programme and enter code
Fig.
24 (level control). Record the value. Disconnect
21
the level hose from the programme unit card A1.
Level value does
not change
The level hose is probably blocked by fluff
or due to incorrect installation. Verify and
clean, or replace the hose.
Level detector on programme unit card A1 is
defective.
Verify the operation of the drain valve using the service
programme (code 22). Remedy or replace the defective
drain valve if necessary.
16
12. Troubleshooting
No water in drum
Level value falls
21
3350
Alt.
Level hose
connection
Service
Manual
Level hose
connection
5566 C
438 9152-31/06
05.03