Service
Manual
13E
The programme unit cannot communicate with the motor controller.
Try to restart the machine with a quick press on the START-button. If the
fault returns, do the following:
• Check that the motor controller gets voltage. The green LED on the
motor controller shall be lightened.
• Check the wire harness between motor controller and timer.
14E
The water level system has not been calibrated (hardware
calibration).
This error code is only displayed for a brief while at the programme start.
Upon this, the machine starts.
The error code implies that calibration of the programme unit level system
has not been verified at the factory.
The machine can be used but, replacement of the programme unit is
recommended.
438 9152-31/06
05.03
12. Troubleshooting
12
21