Electrolux W365H Service Manual page 39

Service
Manual
03E
No signal from the "Door locked" switch at
programme start or during programme
operation.
At programme start, this error code is
suppressed for 10 seconds.
If the power is on, be very careful when
working on the machine.
1. Try to restart the machine (i.e. reset the error code)
by pressing the Start button quickly.
Error message returns
2. Exit the programme using the Start button. Enter the
Fig.
service programme and verify that there is voltage
14
between X30:2 - 6 when the door lock is engaged (code
23 in the service programme).
Fig.
15 No voltage
3. Verify that there is voltage supply between X30:1 - 5
when the door lock is switched on.
Voltage present
4. Is the lock command present? Measure X:92 on the
Fig.
door lock controller.
16
Yes
Troubleshoot cabling between X30 and the actuator. The
actuator/door lock could be defective.
438 9152-31/06
05.03
12. Troubleshooting
No error message
Temporary error in the door
lock or programme unit
Voltage present but LED
does not light
The programme unit card
A1 is probably defective.
No voltage
Troubleshoot the cabling for
the voltage supply (between
the main power switch Q1
and X33).
No
Troubleshoot according to
the error codes in section
29.
14
X33
X30
Alt.
X33
15
Indication Door locked
95 60 40 60 40
16
Actuator
12
5418
X30
5566 D
20
5392
Cables
5368
Cables
6112
13