Table of Contents
Advertisement
Cloning
User's Guide
•
The file must end with EE followed by an end-of-line character (CR
or CR/LF) for the programming changes to be saved and the
decoder to exit programming mode.
The following is an example of an ASCII file used for serial batch
programming:
$+$-
;This is a file example with comments
;The first line started programming mode
;Use predefined default D0
D0
;Enable Code 39--00 is Code 39 enable/dis-
able,
;
1 = enable
001
;Set Code 39 minimum length (01) TO 4 (04)
0104
;Set postamble (B7) to a right tab
B7(TABR)//
;Save changes and exit programming mode
EE
The last line of the file is blank, because a carriage return ended the line
before it.
The following example would have the same results when used to program
the decoder:
$+$-D00010104B7(TABR)//EE
Cloning is a way to copy the setup from one PowerWedge 10 to another.
Once you have programmed the first PowerWedge 10, you can use it as a
master to turn other PowerWedge 10s into clones of the first one.
To program the PowerWedge 10 using cloning . . .
Programming the PowerWedge 10
24
Advertisement
Table of Contents
