PSC PowerWedge 10 User Manual page 30

Programming the PowerWedge 10
NOTE
NOTE
NOTE
25
Cloning will work only if the master and slave are the same model. For exam-
ple, you cannot use a PowerWedge 10 Serial as the master and a keyboard
wedge model or a Mini PowerWedge as the slave.
1. Connect a bar code reader to the connector labeled
programmed PowerWedge 10 (the "master"), and set the On/Off/
Program switch to the
2. Scan the following bar code:
*$+$-EC*
You can also use the bar code menu on the bottom of the PowerWedge 10 to
enter cloning mode. Scan the labels for
This puts the programmed PowerWedge 10 into cloning
mode. While the decoder is in cloning mode, the red and
green light-emitting diodes (LEDs) alternate flashing twice
(that is, the flashing sequence is green-green-red-red,
green-green-red-red, and so on).
3. Remove the bar code reader from the master, and connect one end
of the cloning cable (part number 00-874-25) to
master.
You can also use the bar code menu on the bottom of the PowerWedge 10 to
enter cloning mode. Scan the labels for
position (see
Figure 1
ON
, , and , in that order.
START E C
, , and , in that order.
START E C
1 on the
INPUT
).
1 on the
INPUT
®
PowerWedge 10