Table of Contents
Advertisement
Programming the PowerWedge 10
NOTE
Menu Programming
NOTE
15
To quit Auto-Learn mode without saving the setup, scan the following bar
codes (E first, F second):
*E*
*F*
3. Save the setup by scanning the bar code labeled
bottom of the PowerWedge 10) twice. After the first scan, the
decoder should beep once and the red LED should flash. After the
second scan, the decoder should beep five times and the green LED
should be lit.
E
This programming method makes use of a "menu" of bar codes found on
the bottom of the PowerWedge 10. You can use these bar codes to enter
the programming I.D. numbers and settings listed in
.
page 34
To program the PowerWedge 10 using the bar code menu . . .
If you make a mistake or "get lost" while in programming mode, scan the
bar code. This will reset the decoder to expect a code I.D. number, ignoring
any entries you made since you were last at the base level of programming
mode. To quit programming mode without saving any changes, scan the
code and then the
bar code.
F
1. Scan the
START
*E*
Scan this twice.
bar code on the bottom of the PowerWedge 10.
below (or on the
E
Programming Options on
ESC
bar
E
®
PowerWedge
10
Advertisement
Table of Contents
