PSC PowerWedge 10 User Manual page 14

PowerWedge 10 Installation
Figure 4. Connecting the PowerWedge 10 to a terminal in a multiuser system
Drawing not to scale
Power adapter
NOTE
9
3. S -A C
TAND LONE
to an available serial port on your computer or terminal (see
E C
AVESDROP ONFIGURATION
computer or terminal to the host. Unplug that cable from the com-
puter or terminal's serial port, and attach it to the connector labeled
on the PowerWedge 10 interface cable. Then attach the
COMPUTER
connector labeled
computer or terminal's serial port (see
Connector labeled
COMPUTER
attach to cable from host
Connector
labeled
to serial port on terminal or
computer
shows cable number 00-876-02. Your computer or terminal may
Figure 4
require a different cable.
Use only a power adapter supplied by your Dealer. Using another adapter can
damage the decoder or input device.
4. Attach the small, round plug of the 9-volt power adapter to the
power input jack on the PowerWedge 10 (see
Attach the other end of the cable
ONFIGURATION
Locate the cable that connects your
on the PowerWedge 10 cable to the
TERMINAL
—
—attach
TERMINAL
).
Figure 4
). Plug the other
Figure 1
PowerWedge
).
Figure 3
®
10