Auto-Learn - PSC PowerWedge 10 User Manual

Auto-Learn

NOTE
User's Guide
Auto-Learn is the simplest method of customizing the PowerWedge 10.
With Auto-Learn, you "teach" the decoder to accept the types of bar codes
you use.
The current settings for the PowerWedge 10 remain unchanged unless
they are explicitly set during Auto-Learn programming. For example,
enabling Code 11 does not affect other symbologies. To disable all sym-
bologies except the ones you want to use, program the decoder to use Pre-
defined Default 0 (see page 13) before starting Auto-Learn.
To program the PowerWedge 10 using Auto-Learn . . .
The Auto-Learn feature does not affect terminators or checksums. To set
them, use one of the other programming methods described in this section.
1. Scan the
START
bottom of the PowerWedge 10.)
*$+$-*
START
2. Scan a sample of each of your bar code labels. Be sure the decoder
beeps after each read. It is important that you scan each type of label
(e.g., Code 39, UPC) as well as the smallest and largest bar codes
(e.g., 6 characters and 10 characters) that you want the decoder to
read.
Programming the PowerWedge 10
bar code below. (The bar code also appears on the
14