Baud Rate (I.d. #C1); Data Bits (I.d. #C2); Parity (I.d. #C3) - PSC PowerWedge 10 User Manual

Programming the PowerWedge 10
NOTE
NOTE
NOTE
29

Baud Rate (I.D. #C1)

Bar codes for setting baud rate are on page 48.
This parameter determines the communication speed. The setting you use
for the decoder must match the setting that the host uses.

Data Bits (I.D. #C2)

Bar codes for setting data bits are on page 49.
This parameter specifies the number of data bits in each character.

Parity (I.D. #C3)

Bar codes for setting parity are on page 49.
This parameter specifies the parity of the data characters.
®
PowerWedge 10