Cloning - PSC Mini PowerWedge User Manual

Cloning is a way to copy the setup from one Mini PowerWedge to
another. Once you have programmed the first Mini PowerWedge,
you can use it as a master to turn other Mini PowerWedges into
clones of the first one.
NOTE
To program the Mini PowerWedge using cloning . . .
1. Connect a bar code reader to the input connector on the pro-
grammed Mini PowerWedge (the "master"), and set the On/
Off/Program switch to the
page 1).
2. Scan the following bar code:
This puts the programmed Mini PowerWedge into cloning mode.
NOTE
While the decoder is in cloning mode, the red and green light-emit-
ting diodes (LEDs) alternate flashing twice (that is, the flashing
sequence is green-green-red-red, green-green-red-red, and so on).
20

Cloning

You must use identical decoders to make clones.
For example, you cannot turn a Mini PowerWedge
into a clone of a PowerWedge 10. Also, the units you
are turning into clones must have the same version
of software as the master unit.
*$+$-EC*
You can also use one of the other programming
methods (for example, menu programming or on-
screen programming) to put the decoder into clon-
ing mode.
position (see Figure 1-1 on
ON
Mini PowerWedge
®