Single band frequency range: 470mhz to 700mhz (16 pages)
Summary of Contents for PSC RF Multi SR Six Pack
Page 1
PSC RF Multi SR Six Pack The PSC RF Multi SR Six Pack contains two separate, active 1 x 4 RF splitters for use with up to three slot style receivers. This compact, rugged device was developed using the latest super low noise RF amplifiers and will operate over an extended frequency range of 470Mhz to 700Mhz.
Page 2
SMA connectors on the left side panel of the unit. These offer two additional RF outputs that can be used to feed another PSC RF Multi SR Six Pack or PSC RF Multi SMA or other similar device. The PSC RF Multi Six Pack is equipped with two mounting holes for use in mounting the Six Pack to Sound Devices 664 and 688.
Page 3
2 x SMA RF Outputs (loop throughs) USE: 1. Install your slot style receivers into the openings on the front of the PSC RF Multi SR Six Pack noting the correct direction of the DB-25 connectors. Gently slide the receivers into the slots until you feel the DB-25 connectors line up. Once you feel the connectors line up, firmly press the slot receiver fully into place.
Page 4
5. Connect the PSC RF Multi SR Six Pack cable mounted SMA connectors to your slot receivers using a “criss cross” or X pattern. See photo below: 6. Power up the unit. Note that the power switch lights up blue when the unit is turned *NOTES* 1.
SPECIFICATIONS: Size: 13.25 ” x 5.75” x 1.6” (30.5cm x 14cm x 4cm) Weight: 2.2 Lbs (1 kg) Power: External DC, 18Vdc @ 170 to 210mA Input Impedance: 50 Ohms Input Connector: Output Impedance: 50 Ohms Output Connector: Maximum Input Signal: +13dB Noise Figure: 0.8dB...
Page 6
This product is in compliance with the requirements of the Low Voltage Directive, 73/23/EEC. 93/68/EEC as defined in EN60065, 1993 and/or EN60950/A1/A2/A3: 1995 TRADE NAME: MODEL: RF Multi SR Six Pack RESPONSIBLE PARTY: Professional Sound Corp. 28085 Smyth Drive Valencia, CA 91355 USA...