TITLE
PM43 Service Work Instructions
Rewinder Belt Replacement
1. Remove the media and electronic cover.
2. Disconnect stepper motor cable from motor driver PCBA.
3. Remove the 4 Torx screws securing the stepper motor assembly and motor driver PCBA. See Figure 2.
(Note: Make of the belt tension)
4. Unhook the rewinder belt from the stepper motor assembly and note the position of belt.
5. Reverse the procedure to install replacement rewinder belt.
Figure 2 – Stepper Motor Assembly Removal
Figure 3 – Stepper Motor Assembly Re-Installation
Intermec Proprietary Document
Model
DOCUMENT NO.
PM43,PM43C
SWIPM43x-000
Rewinder Stepper
Guide Pin
Guide Pin
PAGE
Page
62 of 70
Motor Cable
9
X4