TITLE
PM43 Service Work Instructions
Ribbon Take-up Mechanism
OPERATION:
This section covers the replacement of ribbon take-up mechanism. Make note of the guide pins when removing the
mechanism on the electronics side.
Tools Required
Description
Torx Driver
Allen Driver, 1.5mm-2.0mm
Parts Required
Item Part Number
1
710-094S-001
2
650-829-001
3
1-994059-008
Ribbon Take-up Replacement
1. Remove the torx screws securing the ribbon rewind assembly module. See Figure 1.
2. Remove the Allen set screw to remove the ribbon hub. See Figure 2.
3. Remove the C-clips and slide the ribbon rewind assembly toward the electronics side.
4. Reverse the procedure for re-installation.
Ribbon Rewind Assembly Module, PM43
Description
Module, Ribbon Rewind Sub, Assy Spare PM43
Spring,Plate1 inch Core PM43
Screw, MRT 4x8 ZP, T20, (14 lbf.in/16 kgf.cm)
3
Figure 1
1
Intermec Proprietary Document
Model
DOCUMENT NO.
PM43,PM43C
SWIPM43x-000
Part Number
T20
Figure 2
2
Spring Plate, 1 Inch Core, PM43
PAGE
Page
34 of 70
Qty
1
1
5
Location of
Allen set
screw