Mitsubishi Electric AE-200A Instruction Book page 55

(5) Touch the [Groups] tab.
Referring to section 5-2-7, select [AE], [1], [2], [3], or [4]
in the [Controller] section, make group settings for each
AE-200/AE-50/EW-50, and then touch [Save Settings] on each
settings screen.
A message "Collecting connected equipment status data.
Please wait..." will appear.
(6) Make the following settings, as required.
● Block settings (See section 5-2-8 "Blocks".)
● Floor layout settings (See section 5-2-9 "Floor Layout".)
(7) Touch the [Date and time] tab.
Referring to section 5-2-3, set the current date, current time,
and daylight saving time, and then touch [Save Settings].
Note: The AE-200's current date and time will be synchronized to
each AE-50/EW-50 and remote controllers.
(8) Touch [
] at the right top of the screen to move to the
[Monitor/Operation] screen.
Percentages of startup process completion will appear.
The initial settings are completed.
Note: When no communication errors occur, the startup process will
take about two or three minutes after the message appears.
When an error is occurring, it may take about five minutes.
WT07982X03
55