Winding Up The Media Strip In Rewind Mode - CAB SQUIX Operator's Manual

4 Loading Material
4.1.4

Winding up the Media Strip in Rewind Mode

1
2
Figure 13 Guiding the media strip in rewind mode
In rewind mode, the labels are wound up internally after printing for later use.
1. Install rewind guide plate ( 4.4 on page 20).
2. Lift the pinch roller (3) off the rewind assist roller.
3. Guide label strip around the rewind guide plate (2) to the internal rewinder (6).
4. Hold rewinder (6) firmly and turn knob (5) clockwise until it stops.
5. Push label strip under a bracket (4) of the rewinder and turn knob (5) counterclockwise until it stops.
The rewinder is fully spread, thus gripping the label strip firmly.
6. Turn rewinder (6) counterclockwise to tighten the label strip.
7. Turn lever (1) clockwise to lock the printhead.
The label roll is loaded for use in rewind mode.
3 4 5 6 7
15