Loading Fanfold Media - CAB SQUIX Operator's Manual

4 Loading Material
18
4.2

Loading Fanfold Media

6
Figure 16
1. Turn ring (2) counterclockwise, so that the arrow points to the symbol
2. Move the margin stop(s) (1) in such a position that
 SQUIX 4/4P
the media can pass between the margin stop and the chassis.
 SQUIX 4M/4MP/4MT
the media can pass between the two margin stops.
3. Position media stack (4) behind the printer. Ensure that labels on the strip are visible from above.
4. Guide the media strip over the roll retainer (3) to the print unit.
5. Move the margin stop (1) against the media strip until chassis (5) and margin stop (1) or both margin stops touch
the media strip without clamping or bending it.
6. Turn ring (2) clockwise, so that the arrow points to the symbol
retainer (3).
7. Insert media strip into printhead ( 4.1.2 on page 14).
8. Set the label sensor ( 4.1.3 on page 14).
9. Set the head locking system ( 4.3 on page 19).
10. Turn lever (6) clockwise to lock the printhead.
Feed path of fanfold media
1
2
3
4
5
, and thus release the margin stop (1).
, and thus fix the margin stop (1) on the roll
18