Table of Contents
Advertisement
5
Operation
10
5.1
Rewinding Directly onto the Rewind Axle
i
Note!
Remove the spring (2) from the rewind axle!
Caution!
!
Risk of injury by rotating parts!
When switching on the rewinder starts immediately and winds until the material is tightened.
3
6
ER4/210
3
6
ERx/300
Figure 6
Rewinding Directly onto the Rewind Axle
1
2
5
7
5
4
8
9
7
5
4
8
10
9
1. Loosen the screws (1) and remove the spring (2).
3
4
i
Note!
Consider the selected winding direction:
•
The broken line is valid for inside wound
labels.
•
The solid line is valid for outside wound labels.
2. Feed the label strip over the guide axle (9) and under the
roller (8) to the rewind axle (7).
i
Note!
When using a rewinder of the type ERx/300
for winding labels inside, lead the label strip
additionally over the guide axle (10).
Ensure that the label strip touches the disc (6).
3. Attach the label strip appropriately to the rewind axle by
sliding the clamp (5) over the label strip with the clamp
set in the groove of the rewind axle (7).
4. Slide the clamp (5) as far as possible towards the disc
(6).
5. Slide the plate on ER4/210 (4) or ERx/300 (4) onto the
rewind axle so that it slightly touches the label strip. The
label strip must be able to move between the disc and the
plate.
6. Tighten the knurled screw (3) on the plate.
7. Switch on the rewinder at the power switch.
10
Advertisement
Table of Contents
