Demo Mode - Furuno DS-60 Installation Manual

3. MENU SETTINGS
3.3

Demo Mode

The demonstration mode displays and outputs internally generated speed data and
requires external input of navigational data. This mode can be used for demonstration
and to check output to external equipment. "SIM" appears on the screen when the
demonstration mode is active.
1. While pressing the DISP key, press the PWR key to turn on the power. The [Ser-
vice] menu appears.
2. Press  or  to select [SIM], and press the ENT key.
3. Press to select [SET TEST Speed], and press the ENT key. The window for set-
ting of the test speed appears.
4. Press  or  to select the appropriate spped, and press the ENT key.
5. Press the PWR key to turn off the power.
6. Press the PWR key again to turn on the power. The simulation mode starts.
7. To stop the simulation mode, press the PWR key to turn off the power. Do step 1
to re-apply the power. Whenever you open the [Service] menu, the [SIM] menu is
set to [OFF].
8. Press the PWR key to turn off the power.
3-8