Furuno DS-60 Installation Manual page 14

1. INSTALLATION
6. Mount the fixing plate (5) on the transducer (1).
7. Attach seal washer (16) to hex. bolt M8x12 (15).
8. Use hex. bolt (15)(16) assembled at step 7 to fasten the transducer (1) and fixing
plate (5).
Mate bolt head at the top of the transducer with the hole on the fixing plate as
shown in the fig-ure below.
9. Use M16 nut (11), spring washer (12) and flat washer (13) to fix the transducer (1)
w/fixing plate to the fixing flange (4).
M16 hex. nut (11)
Fixing flange (4)
10. For the transducer DS-631, do the following steps:
1) Attach the grommet (supplied) to the location marked with a white line on the
transducer cable.
2) Fix the grommet attached at step 1) to the notch shown below, by using the
cable fixing plate (17), hex. bolt M6x12 (18), spring washer M6 (19).
3) Pass the connector at the end of the transducer cable between the transducer
and M16 bolt, and attach the notch as shown below.
White mark
4) Connect the cable assy. (supplied) to the connector attached at step 3).
Clean the connector faces and pins before the connection.
1-8
M16 spring
washer (12)
M16 flat
washer (13)
Transducer (1)
Transducer cable
Hex. bolt (15)
Seal washer (16)
Fixing plate (5)
Mate bolt head to hole.
Attach the connector to this notch.
Notch
(for grommet)
Pass the cable between
the transducer and this bolt.
Grommet
Cable fixing plate (17)
M6 spring washer (19)
Hex. bolt M6x12 (18)