Furuno DS-60 Installation Manual page 19

11. Apply grease (supplied) to both sides of the gasket 1 (5), and set it on the spacer
(3).
12. Apply grease (supplied) to the inside of the spacer (3).
13. Clean the top and bottom of the gate valve (2), and mount it on the gasket 1 (5)
mounted on the spacer (3) at step 11.
14. Fasten M20 hex. nut (17) and spring washer (18) loosely to the stud bolt of the
spacer (3).
Apply grease to the inside.
15. Apply grease (supplied) to both sides of the gasket 2 (5), and set it on the gate
valve (2).
16. Use hex. nut (17), spring washer (18) and hex. bolt (19) to mount the seachest
cap (4) of the shaft (6) on the gate valve (2).
Hex. bolt (19)
Spring washer (18)
Hex. nut (17)
17. Move the shaft (6) upward and downward by hands to check if it moves smoothly.
Gate valve (2)
M20 hex. nut (17)
M20 spring washer (18)
Gasket 1 (5)
Apply grease to both sides.
Spacer (3)
Seachest cap (4)
Fore mark
Gasket 2 (5)
(Apply grease to both sides.)
1. INSTALLATION
1-13