3.2.3
How to enter offset values
1. Press to select [Offset Data], and ENT key to show the [Offset Data] menu.
2. Select [Trim], and press the ENT key.
3. Enter the offset value for inclined angle, and press the ENT key (setting range:
-12.5 to +12.5°, +: rise at bow).
4. Press to select [Heel], and press the ENT key.
5. Enter the offset value for the heel, and press the ENT key (setting range: -12.5 to
+12.5°, +: rise at port).
6. Press to select [XDCR], and press the ENT key.
7. Enter the offset value if transducer is not installed perfectly with ship's fore-aft line
(setting range: -60.0 to +60.0°). Measure the difference between ship's fore-aft
line and the line on the transducer, and enter it.
Offset: +0
Offset: +a
3. MENU SETTINGS
Offset: -a
3-5