Sp6-Xxx (Peripherals) - Gestetner B147 Service Manual

COPY SERVICE MODE

SP6-XXX (Peripherals)

6-006 [DF Registration Adj.] DF Registration Adjustment
Adjusts the side-to-side and leading registration of originals with the ARDF.
6-006-1 Side-to-Side
6-006-2 Leading Edge
Adjusts the amount of paper buckle to correct original skew for the front and rear
sides.
6-006-3 Buckle: Duplex Front
6-006-4 Buckle: Duplex Rear
Adjusts the erase margin at the original trailing edge.
6-006-5 Rear Edge Erase
6-007 [ADF Input Check]
Displays the signals received from the sensors and switches of the ARDF.
6-007-1 Group 1
6-007-2 Group 2
6-007-3 Group 3
6-008 [ADF Output Check]
Activates the electrical components for functional check.
It is not possible to activate more than one component at the same time.
6-008-1 Fee-in Motor Fwd.
6-008-2 Feed-in Motor Rev.
6-008-3 Drive Motor Fwd.
6-008-4 Reverse Motor Fwd.
6-008-5 Reverse Motor Rev.
6-008-6 Feed Clutch
6-008-7 Inverter Solenoid
6-008-8 Pick-up Motor Fwd.
6-008-9 Pick-up Motor Rev.
6-009 [DF Free Run]
Performs a DF free run in duplex mode or stamp mode.
6-009-1 Duplex Mode
6-009-2 Stamp Mode
6-010 [Stamp Position Adj.] Fax Stamp Position Adjustment
Adjusts the horizontal position of the stamp on the scanned originals.
6-010-1 Stamp Position Adj.
6-016 [Original Size Priority] Original Size Detection Priority
Specifies the original size for a size detected by the original sensor, since original
sensors cannot recognize all sizes.
B147/B149/B190
*CTL [ -3.0 to 3.0 / 0 / 0.1 mm/step ]
[ -42 to 42 / 0 / 1 /step ]
*CTL [ -42 to 42 / 0 / 1 /step ]
[ -45 to 45 / 0 / 1 /step ]
*CTL [ -20 to 10 / -3 / 1 /step ]
5.2.2
*CTL [ -3.5 to 3.5 / 0 / 0.5 mm/step ]
5-64 SM