Sp5-Xxx (Mode) - Gestetner B147 Service Manual

COPY SERVICE MODE

SP5-XXX (Mode)

5-024 [mm/inch Display Selection]
Display units (mm or inch) for custom paper sizes.
5-024-1 mm/inch display
5-045 [Counter Method]
Selects the counting method if the meter charge mode is enabled with SP5-930-001.
NOTE: The counting method can be changed only once, regardless of whether the
counter value is negative or positive.
5-045-1 Counter Method
5-046 [Rom Update Display]
Enables or disables the ROM Update utility. When enabled, this utility will be
displayed in the user program mode.
5-046-1 ROM Update
5-104 [A3/DLT Double Count]
Specifies whether the counter is double clicked for A3/DLT size prints.
5-104-1 Double Count
5-113 [Optional Counter Type]
5-113-1 This program specifies the counter type.
0: None
3: Prepaid card
8: Key counter + Vendor
5-118 [Disable Copying]
5-118-1 This program disables copying.
5-120 Mode Clear Opt. Counter
Removal
5-120-1 This program updates the information on the optional counter. When you install or
remove an optional counter, check the settings.
5-121 Counter Up Timing
5-121-1 This program specifies when the counter goes up. The settings refer to "paper feed"
and "paper exit" respectively.
5-127 APS Mode
5-127-1 This program disables the APS.
B147/B149/B190
*CTL 0: mm (Europe/Asia)
1: inch (USA)
*CTL [ 0 or 1 / 0 / - ]
0: Developments
1: Prints
*CTL [ 0 or 1 / 1 /- ] DFU
0: Enable
1: Disable
*CTL [ 0 or 1 / 0 / - ]
0: Normal count
1: Double count
*CTL
1: Key card (RK 3, 4)
4: Coin rack
*CTL [0: Not disabled/1: Disabled]
*CTL [0: Yes (removed)/1: Standby (installed but not
used)/2: No (not removed)]
*CTL [0: Feed/1: Exit]
*CTL [0: Not disabled/1: Disabled]
5-42
2: Key card (down)
5: MF key card
9: Bar-code Printer
SM