Vehicle Security Alarm - If Equipped; Rearming Of The System; To Arm The System; Starting And Operating - Chrysler Journey Owner's Manual

JOBNAME: cims CHRY OM French PAGE: 13 SESS: 2 OUTPUT: Mon Nov 22 10:53:21 2010 SUM: 41AACDA7
/chry_pdm/chrysler/owners/jcd/og
• This device must accept any interfer-
ence that may be received, including
interference that may cause undesired
operation.
VEHICLE SECURITY ALARM —
IF EQUIPPED
The Vehicle Security Alarm monitors the
vehicle doors and liftgate for unauthorized
entry and the Keyless Enter-N-Go Start/
Stop button for unauthorized operation.
While the Vehicle Security Alarm is armed,
interior switches for door locks are dis-
abled. If something triggers the alarm, the
Vehicle Security Alarm will prevent the
vehicle from starting and provide the fol-
lowing audible and visible signals: the
horn will pulse, the headlights, park lamps
and/or turn signals will flash, and the Ve-
hicle Security Light in the instrument clus-
ter will flash.
THINGS TO KNOW BEFORE STARTING YOUR VEHICLE

Rearming Of The System

If something triggers the alarm, and no
action is taken to disarm it, the Vehicle
Security Alarm will turn the horn off after
three minutes, turn all of the visual signals
off after 15 additional minutes, and then
the Vehicle Security Alarm will rearm itself.

To Arm The System

Follow these steps to arm the theft alarm:
1. Remove the key from the ignition sys-
tem (refer to Starting Procedures
Starting And Operating for further infor-
mation).
• For vehicles equipped with Keyless
Enter-N-Go, make sure the vehicle ignition
system is OFF .
• For vehicles not equipped with Keyless
Enter-N-Go, make sure the vehicle ignition
system is OFF and the key is physically
removed from the ignition.
2. Perform one of the following methods
to lock the vehicle:
• Press LOCK on the interior power door
lock switch with the driver and/or passen-
ger door open.
• Press the LOCK button on the exterior
Passive Entry Door Handle with a valid
Key Fob available in the same exterior
in
zone (refer to Keyless Enter-N-Go in
Things To Know Before Starting Your Ve-
hicle for further information).
• Press the LOCK button on the Remote
Keyless Entry (RKE) transmitter.
3. If any doors are open, close them.
13