Chrysler Journey Owner's Manual page 202

JOBNAME: cims CHRY OM French PAGE: 202 SESS: 2 OUTPUT: Mon Nov 22 10:53:21 2010 SUM: 33700943
/chry_pdm/chrysler/owners/jcd/og
UNDERSTANDING YOUR INSTRUMENT PANEL
which will turn on when the brake fluid
level in the master cylinder has dropped
below a specified level.
The light will remain on until the cause is
corrected.
NOTE: The light may flash momentarily
during sharp cornering maneuvers, which
change fluid level conditions. The vehicle
should have service performed, and the
brake fluid level checked.
If brake failure is indicated, immediate
repair is necessary.
202
WARNING!
Driving a vehicle with the red brake
light on is dangerous. Part of the
brake system may have failed. It will
take longer to stop the vehicle. You
could have a collision. Have the ve-
hicle checked immediately.
Vehicles equipped with the Anti-Lock
Brake System (ABS), are also equipped
with Electronic Brake Force Distribution
(EBD). In the event of an EBD failure, the
Brake Warning Light will turn on along with
the ABS Light. Immediate repair to the
ABS system is required.
Operation of the Brake Warning Light can
be checked by turning the ignition switch
from the OFF position to the ON/RUN
position. The light should illuminate for
approximately two seconds. The light
should then turn off unless the parking
brake is applied or a brake fault is de-
tected. If the light does not illuminate,
have the light inspected by an authorized
dealer.
The light also will turn on when the parking
brake is applied with the ignition switch in
the ON/RUN position.
NOTE: This light shows only that the
parking brake is applied. It does not show
the degree of brake application.
13. Anti-Lock Brake (ABS) Light
art=040400384.tif NO TRANS
This light monitors the Anti-
Lock Brake System (ABS). The
light will turn on when the igni-
tion switch is turned to the ON/
RUN position and may stay on
for as long as four seconds.