Chrysler Journey Owner's Manual page 226

JOBNAME: cims CHRY OM French PAGE: 226 SESS: 2 OUTPUT: Mon Nov 22 10:53:21 2010 SUM: 3790C3F9
/chry_pdm/chrysler/owners/jcd/og
UNDERSTANDING YOUR INSTRUMENT PANEL
• Show Time in Status Bar
When in this display you may turn on or
shut off the digital clock in the status bar.
To change the Show Time Status setting
press the Show Time in Status Bar soft-key
until a check-mark appears next to set-
ting, showing that setting has been se-
lected. Press the back arrow soft-key to
return to the previous menu.
Safety / Assistance
After pressing the Safety / Assistance soft-
key the following settings will be available.
• Front Collision Sensitivity
The Front Collision Warning (FCW) feature
can be can be set to Far, set to Near or
turned Off. The default status of FCW is
the Far setting. This means the system will
warn you of a possible collision with the
vehicle in front of you when you are farther
away. This gives you the most reaction
226
time. To change the setting for more dy-
namic driving select the Near setting. This
warns you of a possible collision with the
vehicle in front of you when you are much
closer. This allows for a more dynamic
driving experience. To change FCW status
press and release the Off, Near or Far
button followed by pressing the arrow
back soft-key.
For further information, refer to "Adaptive
Cruise Control (ACC)" in "Understanding
The Features Of Your Vehicle".
• Park Assist
The Rear Park Assist system will scan for
objects behind the vehicle when the trans-
mission shift lever is in REVERSE and the
vehicle speed is less than 11 mph
(18 km/h). The system can be enabled
with Sound Only, Sound and Display, or
turned OFF. To change the Park Assist
status press and release the Off, Sound
Only or Sounds and Display button fol-
lowed by pressing the arrow back soft-
key. Refer to "Rear Park Assist System" in
"Understanding The Features Of Your Ve-
hicle" for system function and operating
information.
• Tilt Mirrors In Reverse
When this feature is selected, the outside
sideview mirrors will tilt downward when
the ignition is in the RUN position and the
transmission shift lever is in the REVERSE
position. The mirrors will move back to
their previous position when the transmis-
sion is shifted out of REVERSE. To make
your selection, press the Tilt Mirrors in
Reverse soft-key, until a check-mark ap-
pears next to setting, showing that setting
has been selected. Press the back arrow
soft-key to return to the previous menu.