Power Led - Patton SmartNode 5541 Series User Manual

SmartNode 5541 & 4141 Series User Manual
2. The power connection is made via the barrel jack on the rear panel of the SmartNode. No configuration is
necessary for the power supply.
Connect the female end (barrel plug) to the barrel jack on the rear of the SmartNode (see
page 15 for an SN5541 or
an appropriate power outlet.
3. Verify that the green Power LED is lit (see
during boot process of Trinity Software. It becomes solid when the system is up and running.
Congratulations, you have finished installing the SmartNode device! Now go to Chapter 4,
tion" on page 33.
Installing the SmartNode device
figure 4 on page 19 for an SN4141) and the power supply male connectors to
figure 10). It blinks fast during bootloader phase and blinks slow
Figure 10. Power LED
.
3 • SmartNode Installation
figure 2 on
"Initial Configura-
32