SmartNode 5541 & 4141 Series User Manual
Introduction
This section provides information on the cables used to connect the SmartNode device to the existing network
infrastructure and to third party products.
Ethernet
Ethernet devices (10/100/1000 Base-T) are connected to the SmartNode over a cable with RJ-45 plugs. All
Ethernet ports on the SmartNode device are Auto-MDX. Use any straight or crossover cable to a host, hubs,
switches, PCs or other devices.
CAUTION
Connecting both Ethernet ports to the same switch will only work if the
Note
switch has a separate ARP table for each connection.
Figure 15. Typical Ethernet straight-through cable diagram for 10/100Base-T
Figure 16. Typical Ethernet straight-through cable diagram for 1000Base-T
Introduction
The interconnecting cables shall be acceptable for external use
an shall be rated for the proper application with respect to volt-
age, current, anticipated temperature, flammability, and
mechanical serviceability.
RJ-45, male
1
2
3
4
5
6
7
8
C • Cabling
RJ-45, male
1
2
3
4
5
6
7
8
50