Siemens SINAMICS G120 Manual page 27

Some parameters store more than one value. In this case, pressing P does not take you directly
to the value, but to an index that is displayed in brackets [00] above the actual value.
Example for index parameter
• Pressing OK takes you to [00].
• UP takes you to [01], DOWN back to [00].
• Decide on an index number of your choice.
• Press OK again to activate the index and move to the actual value.
• Adjust the value by pressing UP and DOWN.
• Confirm by pressing OK.
OK
If you want to adjust any blinking/active value digit by digit (using the UP and DOWN button
might just take too long), you can always press the OK button longer than two seconds. After
releasing the button, you can change any single digit by using the buttons OK (move to next
digit), ESC (move to previous digit), UP (increase value), and DOWN (decrease value).
OK OK
A complete list of all parameters
can be found in the "Parameter
Manual: Control Units – CU240E/B-2"
available on the Internet as a down-
load at http://support.automation.
siemens.com/WW/view/en/
30563628/133300
Note