Operator Panels (Bop-2 And Iop) - Siemens SINAMICS G120 Manual

Mounting the Operator Panels (BOP-2 or IOP) on the CU
• Remove the cover of the RS232 connection by lifting it up and sliding it to the side.
• Place the bottom edge of the IOP/BOP-2 casing into the lower recess of the
1
2 • Push the IOP/BOP-2 toward the Control Unit until the release-catch clicks into place.
Inverter family SINAMICS G120:
14
Control Unit housing.
Mounting and wiring
2
1