Furuno FCR-2127 Installation Manual page 14

1. MOUNTING
Antenna radiator
Fastening the antenna unit to the mounting platform
The antenna unit may be assembled before hoisting it to the mounting platform. However,
do not lift the antenna unit by the radiator. Always hold the unit by its housing. When using a
crane or hoist, lift the unit by the hoist rings which should be fastened to the bolt fixing
covers of the antenna housing.
DO NOT lift the antenna unit by the radiator; lift it by the
lifting fixtures. (Be sure to remove fixtures after hoisting the
antenna unit.)
Lifting
fixture
1. Construct a suitable mounting platform referring to the outline drawing at the end of this
manual.
2. Drill four mounting holes of 15 mm diameter and one cable entry hole of about 50 mm
diameter in the mounting platform.
3. Lay the rubber mat (supplied) on the mounting platform.
1-4
Guide pin
(XN20AF,
XN24AF
only)
Fastening the radiator to the radiator bracket
CAUTION
130cm
Waveguide
Radiator bracket
Hex bolt (M8x40), 8 pcs.
(XN20AF, XN24AF)
O-ring
NO!