Monitor Unit (Mu-190/Mu-231) Setting - Furuno FCR-2127 Installation Manual

3. SETTING AND ADJUSTMENT
3.2

Monitor Unit (MU-190/MU-231) Setting

The [INSTALLATION SETTING] menu appears only when the power is turned on for the
first time after installation of the monitor unit.
INSTALLATION SETTING
EXT BRILL CTRL
SERIAL BAUDRATE
COLOR CALIBRATION
KEY LOCK
SAVE AND EXIT
Adjust the settings referring to the following table.
EXT BRILL
CTRL
RS-232C
*: "DVI PWR SYNC" is the slide switch at the bottom rear of the monitor unit. Confirm that
this switch is set to "ON" (default setting). See "Slide switch" below for details.
Slide switch
Set the slide switch to "ON" (default setting). This setting automatically powers the monitor
unit on or off according to the DVI signal input. The power switch of the monitor unit is
inoperative.
Note: The OFF position provides control of the monitor unit power with the power switch of
the monitor unit.
How to open the [INSTALLATION SETTING] menu
Turn off the monitor unit. While you hold the [DISP] key, press the [ /BRILL] key to turn on
the monitor unit. Press and hold the [DISP] key for more than five seconds.
Note: When the "DVI PWR SYNC" slide switch is ON, turn on the connected external
equipment while you press the [DISP] key to turn on the monitor unit.
3-2
RS-485 (OFF/DVI1/DVI2/RS-232C/RS-485/USB)
4800bps (4800/9600/19200/38400)
ON (OFF/ON)
ON (OFF/ON)
YES (NO/YES)
SERIAL
BAUDRATE CALIBRATION
9600
COLOR KEY LOCK
ON
Menu
Menu item
DVI PWR
SYNC*
ON ON