5225 Printer - IBM SYSTEM/36 5362 Setting Up

5225 PRINTER
•••••
I~
334
Preparing the IBM 5225 Printer for System Checkout:
1 . Place the Power switch on the 5225 Printer in the
a
(Off)
position.
2. Set the Mode switch to the On Line position.
3. Set the Power switch to the I (On) position.
Wait for the 5225 Attention indicator to come on; then,
several characters are displayed on the 5225 operator panel
for a short time. When the power-on test is complete, the
5225 Attention indicator will be on, and the 5225 display will
be blank or show the letter C or D.
4. Press the Start key.
This turns on the Ready indicator. Your printer is ready for
system checkout.
5. Do you have another printer to prepare for system checkout?
YES
NO
-
-
-
-
-
-
-
-
-
-
-
-
- .-
-
-
-
-
T
Go to the next printer and prepare it for system checkout.
Be sure the 5225 Printer is set up and paper
inserted.
The Mode switch is inside the front cover.
Start Key
Power Switch
Mode Switch
~
"L_--J--JL----J[j'
~"
\:
If a problem occurs, refer to Solving Printer
Problems in the IBM 5225 Printer Operator's
Guide.
••• I •• ~Section 12.G Continued