IBM SYSTEM/36 5362 Setting Up page 19

8
• Unpack the display stations and
printers and place them where
they will be used. (Unpacking
instructions come with each
device.)
• Set up the display stations and
printers one at a time.
• To set up a display station or
printer, use the setup manual for
that device. (The manual is
packed inside the carton on top
of the display station or printer.)
Notes:
1 . When you set up a display station or
printer (using the setup manual for
that device), perform only the
basic
setup
task for that device.
Basic setup
means connect the keyboard cable to
the display station, plug in the power
cord plug, and so on.
Do not
perform any of the four setup
tasks (listed below) in the display
station or printer setup manual:
• Set the address switches
• Set the Terminator switch
• Connect any work station cables
• Perform any test with the display
station or printer connected to the
computer.
The above four tasks will be
performed by you later
in this
manual
2. The personal computer must be set
up and the Display Station Emulation
Adapter or Enhanced Display Station
Emulation Adapter installed before
you can attach the personal computer
to the 5362 Computer.
3. The 5551 System Unit and 5555
Display are set up together using the
manual
5550 System Setup
Instructions,
N: GA18-2166.
4. The IBM 3812 Pageprinter is set up
using the IBM Pageprinter 3812
Hardware Reference Library manual
Setup Instructions 5544-3266.
5. The IBM 4245 Printer is set up by the
Customer Service Representative
(CSR).
• When you have set up all of your
display stations and printer(s),
return to this manual, and go
t o _ .
Device
Manual/Tasks
IBM
3179
IBM
5251
Model 11
~fi I
~,
....
to
Complete