C A 5362 System Reference Code Did Appear On The Computer Output Display - IBM SYSTEM/36 5362 Setting Up

A 5362 SYSTEM REFERENCE CODE DID APPEAR ON THE COMPUTER OUTPUT DISPLAY
?a(l
Cause: One or more of the following conditions existed when you
turned on the computer:
• The Power switch on the system console is set to 0 (Off).
• The keylock on the system console is in the Normal or Locked
position or not fully turned to the Service position.
• The power cord on the system console is not plugged into an
electrical outlet.
• There is no electrical power at the outlet (where the system
console is plugged in).
• The address assigned to the system console is not O.
• The cable between port 0 on the computer and socket 1 on
the system console is one or more of the following:
Brightness control turned down too far
Not connected
Connected improperly
Connected to the wrong socket or port
Defective
• If the system console is a Personal Computer, the Personal
Computer does not have the Display Station Emulation
Adapter or the enhanced Display Station Emulation Adapter
installed.
• If the system console is a Personal Computer, the Personal
Computer does not have the
5250
Emulation Program or
Enhanced 5250 Emulation Program loaded and online.
• ••••• ~ Section 12. C Continued